Regelwerk Preset for 
Behringer Virtualizer DSP1000

Rem: Loads into Preset 64

Fader   1:Effect Algorithm (1-32)
Fader   2:Effect Variation (depends on effect algorithm)
Fader   3:Effect Engine (Both, Left, Right)
Fader   4:Edit A
Fader   5:Edit B
Fader   6:EQ LO
Fader   7:EQ HI

Button  7:In/Out (Toggle)
Button 7 is in fact a Bypass Button.

Fader   8:Effect Mix Intern
Button  8:Intern/Extern
To control the mix by Fader 8, the Effect Setting must be Intern, thus
Fader 8 must be activated (Button 8 toggles between both modes)


Fader   9:Effect Preset Selection (0-99) (Prg Change)
          (0->Preset 1;1->Preset 2;...;99->Preset 100)
Button  9:Effect Preset Selection 
With Fader 9 you can select the Presets of the DSP 1000
(e.g. Preset 10 Magic Speaker) 
You can then change the effect parameters with the faders 1-8.
Button 9 selects the same preset again. This can be used to return 
to the initial parameter settings programmed for the selected Preset.

Fader  12:Select Preset Number
Button 12:Store to the Preset selected by Fader 12
          (0->Preset 1;1->Preset 2;...;99->Preset 100)
Use this with care as it overwrites the factory Presets (of course those
can be reloaded, by reinitializing the DSP1000)
I did put this funtion on button 12, that way it is not so easy to
store by error, I hope)



Settings on the DSP 1000:
1c       --> Midi Channel 1
1C or 3C --> Midi Controller data are received
1P or 3P --> Program Change Messages are received
1S       --> to enable storing


For any questions or problems or infos
Please contact me at:
paul.goergen@ci.educ.lu
